I. Core Advantages of the Equipment 1. Adopts a hydraulic-pneumatic dual-power system with stable pressure controlled within the range of 12-18 MPa 2. Specially designed tungsten steel blade heads with a lifespan of up to 3,000 cutting cycles 3. Compatible with 380V industrial voltage, with a processing capacity of 45-50 standard boards per hour II. Key Operating Procedures (1) Pre-processing Stage - Remove the silicone rubber sealing strips (it is recommended to use a matching heat gun to preheat them to 60°C) - Adjust the positioning fixtures to a distance of 3-5 mm from the component frame (2) Key Parameter Settings - Main oil pressure: 14 MPa in summer/16 MPa in winter - Blade head feed speed: 2 gear levels (3 mm/s for thin frames, 1.5 mm/s for thick frames) - Coolant flow rate: 200 ml per minute III. Maintenance Precautions - After daily operation, it is necessary to clean the rail debris (with a focus on checking the T-grooves) - Replace the hydraulic oil filter (model MX-07B) weekly - Blade head wear warning: replace the blade head immediately when the cutting burr reaches 0.3 mm IV. Common Fault Handling - High oil temperature: check the water level in the cooling system and whether the heat sink is clogged - Positioning deviation: recalibrate the photoelectric sensor (with an error of 0.1 mm or less) - Noise handling: immediately check the lubrication condition of the connecting rod bearings (Attachments) Energy Consumption Data: The actual power consumption for processing each component is 0.18-0.22 kW, which is 67% more energy-efficient than traditional processes [Usage Reminder] It is recommended to use the manufacturer's dedicated frame disassembling toolkit (including an MX-T12 heat gun/MX-G5 dust suction device) to achieve the best operating results.